How to correctly use the saw blade

In order to play its best performance circular saw blades, must strictly observe the following points:
The machine should have a good performance, no swing.
The size of the flange to be consistent, blade diameter is 1/3.
Flange surfaces should be smooth, clean, perpendicular to each other.
Washers should be absolutely vertical.
Shaft should be  polycrystalline diamond  and smooth, does not exceed the tolerance H7
First the blade clean before installation, if sticky resin saw him, wiping away the diluent required, but saw themselves, then coated with a protective layer.
Wipe with hot water can, avoid using corrosive solvents.
If the blades are  synthetic diamond , and should immediately grinding, and keep the original serrated cutting angle.
Grinding not only to choose a suitable diamond grinding wheel, while also using coolant.
Recommends no more than the original blade reamer hole 20 mm, otherwise it will cause loss of Zhang then saw cutting results will be affected.
Each installation must ensure that flanges and gaskets clean and smooth.
After grinding angle and saw the body when you do be careful not to manual operation, can cause jagged fragments and saw the body imbalance.
Polycrystalline diamond installation, careful iron rack and material platform was the same level as required.
Before cutting blade has been installed to check the sturdy blade on the shaft to prevent slipping.